Desksurfer 42FM
Desksurfer 42FM
Desksurfer 42FM

Desksurfer 42FM

Perfect for working over desks in office buildings and reception areas, the Desksurfer 42 FM is designed to provide an easy 1200mm of hands on access to light fittings etc from a 900mm platform...

MAX. REACH HEIGHT:

4.3m

TRAVEL WIDTH:

0.60m

SAFE WORKING LOAD:

150kg

WEIGHT:

80KG

POWER SOURCE:

Manual - By Winch

NEED SOME HELP?

Fill in your details below and a member of our team will get back to you shortly. Need some help? Call us on 01832 770759 or email sales@abilityint.com

  • Ensure only trained competent persons operate and use the DESKSURFER and a Risk Assessment has been conducted for Work at Height.
  • Inspect the DESKSURFER before use and have a formal inspection conducted at regular intervals, depending on frequency of use; keep records of each inspection.
  • Do not use if DESKSURFER is damaged, incomplete, or improperly assembled.
  • DESKSURFER must be vertical and used on level and firm floors. Should floors/ground be uneven, OPTION 5, Adjustable legs, must be specified and used. Level unit using the bullseye spirit level located on the base frame.
  • Ensure Stabilisers/Outriggers are correctly positioned i.e. V marks are aligned, castors are in contact with the floor and couplers are clamped tight, using firm thumb and finger pressure on the wing nuts.
  • Ensure all castor wheels are in contact with the floor; when DESKSURFER is positioned for use, apply the foot brakes on all 4
    outboard (of the desk) castors. Apply all six castor brakes when the DESKSURFER is positioned for use away from desks.
  • Do not raise or lower the mast and platform with a person, or tools and materials, onboard the DESKSURFER. Ensure mast latch hooks are engaged on a rung, or stub rungs, before use.
  • Never allow the DESKSURFER winch wire to become slack by overwinding the handle in the DOWN direction.
  • Beware of strong wind conditions including the funneling effect that can occur with open-ended buildings etc. Do not use the DESKSURFER if wind speed is likely to exceed 7.7 meters per second, 17mph or Beaufort force 4 (Moderate breeze: dust and paper starts to lift and be blown about).
  • Attach the two safety bars once inside the DESKSURFER guardrailed platform area.
  • Always keep your body within the DESKSURFER guardrailed platform area. Reach out with arms and hands only. Do not stretch.
  • When moving the DESKSURFER, lower the mast and push or pull using manual effort from the base only and without a person or materials on the platform.
  • Beware of all obstructions, especially overhead; also unguarded electrical supply, power lines, and cables.
  • Do not overload the DESKSURFER. The maximum Safe Working Load is 150kg (23.5 stone).
  • If in doubt about the safe use of the DESKSURFER, contact the supplier for advice

Specifications

Max. Reach Height 5.50M
Safe Working Load 150KG(23.5STONE)
Power Source Manual
Weight 140KG
Travel Width 0.60m
Equipment Use Indoor & Outdoor
Lifting Mechanism Mast Lift
Chassis Type Push around

 

MAINTENACE RULES

  • Keep equipment clean and inspect before and after use for damage. Use serviceable equipment only.
  • All working parts e.g. castors, legs, mast latch and stabiliser clamps should be lubricated lightly with oil as necessary.
  • Repairs should only be carried out by the supplier or other competent person approved by the supplier.

SAFE WORKING LOADS

  • Maximum Safe Working Load: 150kg (23.5 stone).

EMERGENCY RESCUE

  • Should a person need rescuing the winch mechanism can be used for lowering the platform, with the person on-board, to the
    lowest platform height setting of the respective Desksurfer models designated as 42UM or FM, 49FM, 55FM and 60FM.(Model
    35 is a low height unit without a winch).
  • NOTE:The above is a one off procedure and after the emergency rescue, the DESKSURFER must be quarantined (not be used) and returned for a thorough check. This check will include re-aligning the mast; changing the winch wire; inspecting and if necessary changing the winch; checking all fastenings and joints; servicing all moving parts; proof load testing and re-issue of new Certificate of Conformity; signed and dated Service/Inspection label certifying NO Defects. Should your DESKSURFER be used for an emergency rescue as related above, then contact the supplier to arrange collection for the above mentioned thorough check to be carried out.

WARNING

  • INJURY OR DEATH MAY RESULT FROM FAILURE TO COMPLY WITH THE DESKSURFER OPERATOR NSTRUCTIONS, SAFETY GUIDE, MAINTENANCE RULES AND SAFE WORKING LOAD

COMPLIANCE & CE MARKING

  • Ability International Limited: BS EN ISO 9001 :2008 Registered. Certificate No:
    4011767

    safecontractor Accreditation. Certificate N0:BQ7332

MANUFACTURED BY

  • Ability International Limited. (details on front cover). We reserve the right to change and improve our speci

GUARANTEE PERIOD

  • 3 years from date of delivery and subject to any fault that is genuinely attributable to us

© 2025 Ability International Ltd | Company: 2043599 | VAT: 445 661 831 | All Rights Reserved